Eleaf GS-AIR 2 Dual coil clearomizer - 2ml 14mm

Eleaf GS-AIR 2 Dual coil clearomizer - 2ml 14mm

Eleaf GS-Air 2 clearomizer was specifically designed for iStick Basic. Thanks to its sleek design and 14mm in diameter it nicely fits inside the iStick Basic on the magnetic connector. This does not mean that you cannot use this clearomizer with another battery or MOD.

Parameters:
Length: 70 mm
Diameter: 14 mm
Heating head resistance: 0,75Ω (8W-25W)
Capacity: 2 ml
Thread: 510

Kapacita

Decent 2 ml capacity is rather standard and especially with clearomizeru as GS-Air 2, where the resistance of heating heads is 0,75Ω, it is good to have a little bit more of e-liquid. Another advantage is that you are not limited only to these sub-ohm coils, but you can use 1,2Ω heads instead.

Indisputable advantage over traditional clearomizers is also the base with an airflow control. While this is standard with larger tanks, occasionally we seem it in smaller clearomizers and it definitely helps, either with the looseness of the puffs or with the vapor production.

Although it was created mainly for iStick Basic, this clearomizer works well with any other MOD or battery with an adjustable voltage or wattage. Heating heads can withstand higher wattage than those in ordinary clearomizers and it would be a shame not to use it with a little bit more powerful device than just an eGo battery.

Instructions for refilling:
1. Turn the GS-Air 2 with the mouthpiece down and unscrew the bottom base.
2. Fill the clearomizer with your e-liquid - never more than is the threshold of the middle tube (which is intended as an air passage).
3. Screw the bottom base back.
4. Before using a new heating head we always recommend to wait a few minutes so the heating head had enough time to soak up the e-liquid.

Instructions for replacing heating head:
1. Turn the GS-Air 2 with the mouthpiece down and unscrew the bottom base.
2. Remove the old heating head from the base, and screw in the new one (always make sure that the head is properly tightened at the base).
3. Screw the bottom base back.
4. Before using a new heating head we always recommend to wait a few minutes so the heating head had enough time to soak up the e-liquid.to soak up the e-liquid.

TIP: We recommend a few drops of e-liquid directly on the cotton in the new heating head.